1) Werkstatt wechseln. Hat der RR noch Garantie? Sonst LR anschreiben, dass das bei einem 100000EUR Auto doch nicht sein kann.

2) Schwierig, weil ja da ein Airbag drin ist. Du kannst von der Seite ins armaturenbrett kommen:
Zitat
1. Release sufficient door aperture seal to access closing panel.
2. Release 3 clips securing end closing panel to fascia and carefully remove panel.
NOTE: Do not carry out further dismantling if component is removed for access only.
3. Remove 3 retaining clips from closing panel.

Refit
1. Fit retaining clips to closing panel.
2. Position closing panel to fascia, align and secure clips.
3. Fit seal to door aperture.

Willst Du weiter rein sind die Hölzer aussen dran:

Zitat
Finisher - upper - drivers side
$%76.46.12
Remove
1. Remove fascia end closing panel.
+INTERIOR FITTINGS, REPAIRS, Closing panel - fascia end.
2. Remove face level air vent.
+HEATING AND VENTILATION, REPAIRS, Fresh air vent - face level.
3. Remove 'A' post upper trim finisher.
+INTERIOR FITTINGS, REPAIRS, Trim finisher - 'A' post - upper.
4. Remove 3 Torx screws securing upper finisher to fascia.
5. Release upper finisher from fascia and disconnect switch multiplug.
6. Disconnect footwell lamp multiplug.
7. Remove upper finisher.
NOTE: Do not carry out further dismantling if component is removed for access only.
8. Remove switch assembly from finisher.
9. Depress clips and remove footwell lamp assembly from finisher.


Finisher - upper - passenger's side
$%76.46.13
Remove
1. Remove 'A' post upper trim finisher.
+INTERIOR FITTINGS, REPAIRS,Trim finisher - 'A' post - upper.
2. Remove fascia end closing panel.
+INTERIOR FITTINGS, REPAIRS, Closing panel - fascia end.
3. Remove face level air vent.
+HEATING AND VENTILATION, REPAIRS, Fresh air vent - face level.
4. Remove 3 Torx screws securing upper finisher to fascia.
5. Remove screw securing rear of cup holder to inner mounting bracket.
6. Release finisher from carrier and disconnect footwell lamp assembly multiplug.
7. Remove upper finisher.
NOTE: Do not carry out further dismantling if component is removed for access only.
8. Depress 3 clips and remove passenger cup holder from finisher.
9. Depress clips and remove footwell lamp assembly from finisher.

Bei allem was darüber hinaus geht wird zunächst der Airbag deaktiviert was ohne Diagnosegerät nicht geht.

Gruß

Carsten ;-)

B: Diverse Range Rover Teile Classic und 38a